Merkleroot? How do I generate that?

[Autotunafish]

I think mining.notify is where that is

Miner- Claymore's Zcash Miner

I have an R9 290x and an RX 480, and I’m using the most recent catalyst drivers. Yesterday I tried setting up Nicehash to see what I could make with that, but I never made it past the bench-marking phase. The benchmark results for the R9 290x just showed up as “Awaiting Results”. So I decided to put that on hold for the moment and tried to launch Claymore again to mine Zcash. After a couple of minutes my PC fully shut down, I started it back up, got it mining again, and of course it shut down a…

Looking for a little help Programming Miner in Go

Not sure about your naming, but if you’re mining with pool, during “mining.subscribe” you should get nonce1, the first part of your nonce. Also you should get target (difficulty) in “mining.target”. What you’ve posted as “params-1” looks like “mining.notify” (job-id, version, prevhash, merkle, reserved-zeroes, time, bits and clean-job-flag). Could not check your solution because you haven’t show your nonce1 and target.