Running Claymore Version 11 (now)
Win 10 (64b)
Catalyst 15.12
-i 8
running with ASM on
1 Nitro R9 Fury (monitor) @ 356 , goes up to 380 when I turn the monitor off
4 Nitro R9 Fury’s @ 389/392
2 Nitro R9 Fury X @ 419/422
Ran for 18 hours no restarts!
My constant average is 2746
I went to check on it because my average dropped to 2600, log file was over 70mb’s, stopped and restarted claymore, and SOL’s were very bad - 70-90… restarted system and everything went back to normal, see screenshot
Hello.
My miner crashes very often . I use claymore v11 with Radeon Crimson 15.12 driver on Windows 10 freshly installed .
Few minutes after i start it i get a BSOD with something like this :
SYSTEM_THREAD_EXCEPTION_NOT_HANDLED (atikmdag.sys)
And the computer restarts.
The mobo is a MSI z77a-gd65 with 3Gb of RAM and 32GB virtual memory set by me, a shitty Intel Celeron G…something CPU, a toshiba 5400 rpm 80GB laptop HDD, 2x600W + 1x700W Corsair PSUs and 6 x Gigabyte HD 7970 GPUs.
Moreover ,If it doesn’t crash from the start ,after i start the Claymore miner and it connects to the pool (btw i tried to mine ZCL on Suprnova) and mines for less than 1 minute , i get this error :
WATCHDOG: GPU 4 hangs in OpenCL call, exit…
And whenever this occurrs the Claymore miner freezes and i cannot close it , not event from task manager… This is so annoying because i lost so much time trying to put this miner online and i cannot spend too much time on debugging it because of my daily job .
What do you guys think is the issue ? Is the CPU a bottleneck ? Should i migrate to Linux ? if yes what distro would you recommend ? Please help me !
Thanks!
I removed the GPU 4 and started the miner. After less than 1 minute i got the same error but for a different GPU. I removed that GPU also and started the miner but got the same error for 2 other GPUs. Tomorrow i hope i will uninstall and reinstall the driver and start over again…So you say after i reinstall the driver to put only one GPU and mine for few minutes to see how it behaves ? Then add a second GPU and mine for few minutes and so on ?
Btw is there any difference in hash rate bwtween Linux and Windows ?
I’m trying to get the clock, voltage and powerlimit options to work, but I’m guessing you need the AMD ADL for that. I just can’t get this installed on my Ubuntu 16.04.
Does anyone know a solution?
I am using 16.3.2 and no mods…all stock settings. MSI Z97 gaming board. I do not use -cclock. If you are using MSI Z97 board, make sure you set in bios latency 96 and gen 2.
I have 5 R9 Fury’s and 2 R Fury X’s, I am running Claymore version 11.1 with drivers 16.3.2 with great results!
in fact since installing 11.1, I am 22 hours stable
